Campbell Hausfeld VT6195 Air Compressor Manual

The Campbell Hausfeld VT6195 is a versatile air compressor designed for a variety of tasks, including inflating tires, powering pneumatic tools, and more. This manual provides essential information on safety, features, installation, operation, and maintenance.

1. Features at a Glance 2. Installation 3. First-Time Setup 4. Specifications 5. Controls and Settings 6. Connecting Devices 7. Operating the Compressor 8. Maintenance 9. Troubleshooting 10. Safety Information

Features at a Glance

Key components: Oil-free pump, 6-gallon tank, 125 PSI maximum pressure, easy-to-read pressure gauge, and quick-connect coupler.

Feature	Description
Oil-free pump	Requires no maintenance and provides clean air.
6-gallon tank	Offers a good balance of portability and air storage.
125 PSI maximum pressure	Suitable for a variety of applications.
Pressure gauge	Easy monitoring of air pressure levels.
Quick-connect coupler	Facilitates fast and easy tool changes.

Installation

Unpack the compressor and place it on a stable surface. Ensure adequate ventilation during operation.

Connect the air hose to the quick-connect coupler.
Plug the compressor into a grounded outlet.
Check that all connections are secure before starting.

WARNING! Always operate the compressor in a well-ventilated area to avoid overheating.

First-Time Setup

Before using the compressor, ensure that it is properly set up and all safety precautions are followed.

Check the oil level (if applicable) and fill as needed.
Set the desired pressure using the pressure regulator.
Test the compressor by running it briefly to ensure proper operation.

CAUTION! Do not exceed the maximum pressure rating of the compressor.

Specifications

Model: VT6195
Tank Capacity: 6 gallons
Maximum Pressure: 125 PSI
Power Source: 120V AC
Weight: Approximately 50 lbs
Dimensions: 24 x 18 x 18 inches
Noise Level: 68 dBA

Controls and Settings

The compressor features a pressure regulator, on/off switch, and pressure gauge for easy operation.

Pressure Regulator: Adjusts the output pressure for different applications.

On/Off Switch: Controls the power to the compressor.

Connecting Devices

Ensure the compressor is off before connecting any tools or devices.

Attach the air hose to the quick-connect coupler.
Connect your pneumatic tool to the other end of the air hose.
Turn on the compressor and adjust the pressure as needed.

Tip: Always check for leaks in the connections before use.

Operating the Compressor

Follow these steps to operate the compressor safely and effectively.

Turn on the compressor using the on/off switch.
Allow the compressor to build pressure until it reaches the set level.
Use your pneumatic tool as needed, monitoring the pressure gauge.

WARNING! Do not operate the compressor in enclosed spaces without proper ventilation.

Maintenance

Regular maintenance is essential for optimal performance and longevity of the compressor.

Check and replace the air filter as needed.
Drain the tank regularly to remove moisture.
Inspect hoses and connections for wear and tear.

CAUTION! Always unplug the compressor before performing maintenance.

Troubleshooting

Symptom	Possible Cause	Corrective Action
Compressor won't start	Power supply issue	Check outlet and power cord.
Low pressure	Leak in hose	Inspect and replace damaged hoses.
Excessive noise	Loose parts	Tighten any loose screws or components.
Tank won't fill	Faulty pressure switch	Replace the pressure switch if necessary.

Service: For further assistance, contact Campbell Hausfeld customer support.