Campbell Hausfeld IN614207AV Air Compressor Manual

The Campbell Hausfeld IN614207AV is a versatile air compressor designed for a variety of tasks, including inflating tires, powering air tools, and more. This manual provides essential information on safety, features, installation, operation, and maintenance to ensure optimal performance and longevity of your air compressor.

1. Features at a Glance 2. Installation 3. First-Time Setup 4. Specifications 5. Controls and Settings 6. Connecting Devices 7. Operating the Compressor 8. Maintenance and Care 9. Troubleshooting 10. Safety Information

Features at a Glance

Key components: Oil-free pump, 6-gallon tank, 125 PSI maximum pressure, quick coupler, and built-in pressure gauge.

Feature	Description
Oil-free pump	Requires no maintenance and provides clean air.
6-gallon tank	Provides ample air storage for various tasks.
125 PSI maximum pressure	Suitable for a wide range of applications.
Quick coupler	Allows for easy attachment of air tools.
Built-in pressure gauge	Monitors air pressure for optimal performance.

Installation

Unpack and inspect the contents. Place the compressor on a stable surface in a well-ventilated area.

Connect the air hose to the quick coupler.
Ensure the drain valve is closed before operation.
Plug the compressor into a grounded outlet.

WARNING! Ensure the compressor is on a flat surface to avoid tipping.

First-Time Setup

Power on the compressor and set the desired pressure using the regulator.

Check oil level (if applicable).
Set the pressure regulator to the desired PSI.
Test the compressor by running it briefly.

CAUTION! Do not exceed the maximum pressure rating.

Specifications

Model: IN614207AV.
Tank Size: 6 gallons.
Maximum Pressure: 125 PSI.
Power Source: 120V AC.
Weight: Approximately 50 lbs.
Dimensions: 24 x 18 x 18 inches.
Noise Level: 68 dBA.

Controls and Settings

Access the pressure regulator and on/off switch located on the front panel.

Pressure Regulator: Adjusts the output pressure for connected tools.

On/Off Switch: Powers the compressor on and off.

Connecting Devices

Connect air tools using the quick coupler.

Ensure the compressor is off before connecting tools.
Match the tool's connector to the quick coupler.
Turn on the compressor and adjust the pressure as needed.

Tip: Always check for leaks after connecting devices.

Operating the Compressor

Follow these steps to operate the compressor safely and effectively.

Turn on the compressor using the on/off switch.
Adjust the pressure regulator to the desired PSI.
Connect your air tool and begin operation.

WARNING! Do not exceed the maximum pressure rating of your tools.

Maintenance and Care

Regular maintenance is essential for optimal performance.

Drain the tank after each use to prevent moisture buildup.
Check and replace the air filter as needed.
Inspect hoses and connections for wear and tear.

CAUTION! Always unplug the compressor before performing maintenance.

Troubleshooting

Symptom	Possible Cause	Corrective Action
Compressor won't start	No power supply	Check the power cord and outlet.
Low pressure	Leak in hose	Inspect hoses for leaks and replace if necessary.
Excessive noise	Loose parts	Tighten any loose screws or components.
Tank won't fill	Faulty pressure switch	Contact customer service for assistance.

Service: For support, contact Campbell Hausfeld at 1-800-543-6400.