Campbell Hausfeld HS5500 Air Compressor Manual

The Campbell Hausfeld HS5500 is a powerful air compressor designed for a variety of applications, including inflating tires, powering air tools, and more. This manual provides essential information on safety, features, installation, operation, and maintenance.

1. Features at a Glance 2. Installation 3. First-Time Setup 4. Specifications 5. Controls and Settings 6. Connecting Devices 7. Operating the Compressor 8. Maintenance and Care 9. Troubleshooting

Features at a Glance

Key components: 5.5 HP motor, 20-gallon tank, oil-lubricated pump, pressure regulator, and quick-connect fittings.

Feature	Description
5.5 HP Motor	Provides ample power for various applications
20-Gallon Tank	Offers extended run time and reduced cycling
Oil-Lubricated Pump	Ensures durability and efficient operation
Pressure Regulator	Allows for precise control of output pressure
Quick-Connect Fittings	Facilitates easy attachment of air tools

Installation

Unpack the compressor and place it on a stable, level surface. Ensure adequate ventilation.

Connect the air hose to the compressor's outlet.
Plug the compressor into a grounded outlet.
Check all connections for leaks before starting.

WARNING! Always use proper safety equipment when operating the compressor.

First-Time Setup

Before using the compressor, follow these initial setup steps.

Fill the oil reservoir as per the specifications.
Set the desired pressure using the pressure regulator.
Test the compressor with a low-pressure application.

CAUTION! Ensure all safety guards are in place before operation.

Specifications

Motor Power: 5.5 HP.
Tank Capacity: 20 gallons.
Max Pressure: 125 PSI.
Weight: 120 lbs.
Dimensions: 30 x 18 x 36 inches.
Noise Level: 75 dB.
Power Source: 120V AC, 60Hz.

Controls and Settings

Access the pressure settings via the regulator knob. The on/off switch is located on the front panel.

Safety Features: Automatic shut-off, pressure relief valve, and thermal overload protection.

Connecting Devices

Ensure the compressor is off before connecting any tools.

Attach the air hose securely to the compressor.
Connect your air tool to the other end of the hose.
Turn on the compressor and adjust the pressure as needed.

Tip: Always check for leaks after connecting devices.

Operating the Compressor

To operate the compressor, follow these steps:

Turn on the compressor using the power switch.
Allow the tank to fill to the desired pressure.
Use your air tool as needed.

WARNING! Do not exceed the maximum pressure rating of your tools.

Maintenance and Care

Regular maintenance is essential for optimal performance.

Check and change the oil regularly.
Drain the tank to remove moisture.
Inspect hoses and fittings for wear.

CAUTION! Always unplug the compressor before performing maintenance.

Troubleshooting

Symptom	Possible Cause	Corrective Action
Compressor won't start	Power supply issue	Check outlet and power cord.
Low pressure	Leak in hose	Inspect and replace damaged hoses.
Excessive noise	Worn bearings	Contact service for repair.
Overheating	Blocked vents	Ensure vents are clear and clean.

Service: For assistance, contact customer support at 1-800-543-1234.