Campbell Hausfeld CE5002 Air Compressor Manual

The Campbell Hausfeld CE5002 is a versatile air compressor designed for a variety of tasks, including inflating tires, powering pneumatic tools, and more. This manual provides essential information on safety, features, installation, operation, and troubleshooting to ensure optimal performance.

1. Features at a Glance 2. Installation 3. First-Time Setup 4. Specifications 5. Controls and Settings 6. Connecting Devices 7. Operating Instructions 8. Maintenance 9. Safety Information 10. Troubleshooting

Features at a Glance

Key components: Oil-free pump, 6-gallon tank, 125 PSI maximum pressure, easy-to-read pressure gauge, and quick-connect coupler.

Feature	Description
Oil-free pump	Requires no maintenance and provides clean air.
6-gallon tank	Offers a good balance between portability and air capacity.
125 PSI maximum pressure	Suitable for a variety of applications.
Pressure gauge	Easy monitoring of air pressure levels.
Quick-connect coupler	Allows for easy attachment of air tools.

Installation

Unpack the compressor and place it on a stable surface. Ensure adequate ventilation during operation.

Connect the air hose to the quick-connect coupler.
Plug the compressor into a grounded outlet.
Ensure the pressure switch is set to the off position before starting.

WARNING! Always ensure the compressor is on a flat surface to avoid tipping.

First-Time Setup

Power on the compressor; allow it to build pressure before use.

Set the desired pressure using the pressure regulator.
Check for any air leaks before connecting tools.
Ensure the safety valve is functioning properly.

CAUTION! Do not exceed the maximum pressure rating.

Specifications

Tank Size: 6 gallons.
Maximum Pressure: 125 PSI.
Power Source: 120V AC.
Weight: Approximately 50 lbs.
Dimensions: 24 x 18 x 18 inches.
Noise Level: 68 dBA.

Controls and Settings

Access the pressure regulator and on/off switch located on the front panel. The pressure gauge displays current tank pressure.

Safety Features: Includes a safety valve and thermal overload protection.

Connecting Devices

Ensure the compressor is off before connecting any tools.

Attach the air hose to the quick-connect coupler.
Connect your pneumatic tool to the other end of the hose.
Turn on the compressor and set the desired pressure.

Tip: Always check for leaks after connecting devices.

Operating Instructions

To operate the compressor, turn on the power switch and allow it to reach the set pressure before using any connected tools.

Monitor the pressure gauge during operation.
Turn off the compressor when finished and disconnect tools.

WARNING! Do not operate the compressor in wet conditions.

Maintenance

Regular maintenance is essential for optimal performance.

Drain the tank after each use to prevent moisture buildup.
Check the air filter regularly and replace if necessary.
Inspect hoses and connections for wear and tear.

CAUTION! Always unplug the compressor before performing maintenance.

Safety Information

Read all safety instructions before operating the compressor. Always wear appropriate personal protective equipment.

WARNING! Failure to follow safety instructions may result in serious injury.

Troubleshooting

Symptom	Possible Cause	Corrective Action
Compressor won't start	Power supply issue	Check power cord and outlet.
No pressure	Leak in system	Inspect hoses and connections for leaks.
Excessive noise	Loose parts	Tighten all screws and bolts.
Pressure drops	Faulty pressure switch	Replace pressure switch if necessary.

Reset: Unplug and plug back in to reset the compressor.

Service: For assistance, contact Campbell Hausfeld customer service.