Campbell Hausfeld Air Compressor 110 PSI Manual

The Campbell Hausfeld Air Compressor is designed for a variety of tasks, including inflating tires, powering air tools, and more. With a maximum pressure of 110 PSI, this compressor is ideal for both home and professional use. Below are key sections for safety, features, installation, setup, operation, and troubleshooting.

1. Features at a Glance 2. Installation 3. First-Time Setup 4. Specifications 5. Controls and Settings 6. Connecting Devices 7. Operating the Compressor 8. Maintenance 9. Safety Information 10. Troubleshooting

Features at a Glance

Key components: Oil-free pump, 6-gallon tank, easy-to-read pressure gauge, and quick-connect coupler.

Feature	Description
Oil-Free Pump	Requires no maintenance and provides clean air.
6-Gallon Tank	Provides ample air storage for various tasks.
Pressure Gauge	Easy-to-read gauge for monitoring air pressure.
Quick-Connect Coupler	Allows for easy attachment of air tools.
Portable Design	Lightweight and easy to transport.

Installation

Unpack the compressor and inspect for any damage. Place it on a stable surface.

Connect the air hose to the quick-connect coupler.
Ensure the drain valve is closed before starting.
Plug the compressor into a grounded outlet.

WARNING! Ensure the compressor is on a flat surface to avoid tipping.

First-Time Setup

Power on the compressor and allow it to build pressure.

Set the desired pressure using the regulator.
Check for any air leaks before use.
Attach your air tool and begin operation.

CAUTION! Always wear safety goggles when operating air tools.

Specifications

Max Pressure: 110 PSI.
Tank Size: 6 gallons.
Power Source: 120V AC.
Weight: Approximately 40 lbs.
Dimensions: 24 x 16 x 18 inches.
Noise Level: 68 dBA.

Controls and Settings

Access the pressure regulator and on/off switch located on the front panel.

Pressure Regulator: Adjusts the output pressure for your tools.

On/Off Switch: Powers the compressor on and off.

Connecting Devices

Ensure the compressor is off before connecting any devices.

Attach the air hose to the quick-connect coupler.
Connect your air tool to the other end of the hose.
Turn on the compressor and set the desired pressure.

Tip: Always check for leaks before starting your task.

Operating the Compressor

Follow these steps to operate the compressor effectively.

Turn on the compressor and wait for it to reach the desired pressure.
Use your air tool as needed.
Monitor the pressure gauge during operation.

WARNING! Do not exceed the maximum pressure rating.

Maintenance

Regular maintenance is essential for optimal performance.

Drain the tank after each use to prevent moisture buildup.
Check and replace the air filter as needed.
Inspect hoses and connections for wear and tear.

CAUTION! Always unplug the compressor before performing maintenance.

Safety Information

Always follow safety guidelines when operating the compressor.

Wear safety goggles and hearing protection.
Keep the compressor in a well-ventilated area.
Do not operate in wet conditions.

Troubleshooting

Symptom	Possible Cause	Corrective Action
Compressor won't start	Power supply issue	Check outlet and power cord.
Low pressure	Leak in hose	Inspect and replace damaged hose.
Excessive noise	Loose parts	Tighten all screws and bolts.
Tank won't fill	Faulty pressure switch	Replace pressure switch if necessary.

Service: For assistance, contact Campbell Hausfeld customer support.